Installation Instructions; Intended Use; Getting Started; Unpacking And Equipment Supplied - Sartorius Secura 35 Instrucciones De Instalación Y Manejo

2.2 Installation Instructions

Do not operate the balance if its housing or AC
adaptor is damaged. Immediately disconnect the
damaged device from the power by pulling the plug.
Do not expose the balance, its AC adaptor or
the accessories supplied by Sartorius to extreme
temperatures, aggressive chemical vapors, moisture,
shocks, vibrations or strong electromagnetic fields.
Observe the conditions of operation described in the
"Technical Data"!
The operator shall be solely responsible for any
modifications to the equipment and for connecting
any cables or equipment not supplied by Sartorius!
Information on operational quality is available upon
request from Sartorius.
You should only use peripherals supplied by
Sartorius!
Note the IP protection class of the balance and its
AC adaptor! Do not allow liquid penetration.
The protection class specifies the suitability of
equipment for various environmental conditions
(moisture, foreign bodies).
Before cleaning the AC adaptor or the balance:
Unplug from the mains power.
The balance may only be opened by specialized
personnel trained by Sartorius. Do not open the AC
adaptor.
Warnings at the Place of Installation and During Operation:
If glass breaks, there is a risk of injury posed by cuts
on glass edges.
Lay the cables where they pose no risk of causing
someone to trip.
Observe the additional safety and danger information in the
following chapters.

2.3 Intended Use

This high-resolution balance is exclusively for use in laboratories
and indoors under normal atmospheric conditions. It was developed
specifically for the exact determination of the mass of materials in
liquid, paste, powder or solid form.
Appropriate containers must be used for each type of sample
material.
4
Installation and Operating Instructions Manual Secura

3. Getting Started

3.1 Unpacking and Equipment Supplied

Open the packaging, making sure to remove of all parts carefully.
t t
After unpacking the device, check it immediately for any external
t t
damage.
If you detect any damage, proceed as directed in the "Care and
y t
Maintenance" chapter.
Save all parts of the original packaging for any future
y t
transportation. During shipment, please do not leave cables
plugged in!
The following parts are included in the equipment supplied:
Components
Model
Draft shield
Weighing pan: d 80 mm
Weighing pan: d 90 mm
AC adaptor with country-
specific power plug
In-use dust cover
Dust cover
Installation and
Operating Instructions
Application guide

3.2 Installing the Balance

, Quintix
® ®
The balance must be disconnected from the mains
power for all assembly work.
Secura
®
225D 324
125
x x
x –
Optional x
x x
x x
x x
x x
x x
Collection Container Installation
Insert the collection container into
t t
the balance.
Assembling the Panels
Press against the front of the cover
t t
from both sides and fold it upwards.
Inserting the front panel of the
t t
draft shield:
− Insert the panel on the top
into the guide rails of the draft
shield.
− Press the panel gently upwards,
while simultaneously pressing
downwards into the slot of the
draft shield.
− The panel must latch into the slot.
Quintix
®
125D 35
65
x x
x x
Optional Optional
x x
x x
x x
x x
x x