Philips TT3003 Manual Del Usuario página 25

2 Press the on/off button to switch on the
appliance.
-
Intensity light 1 goes on automatically to
indicate that the appliance is switched on at
default intensity 1.
Note: It is normal that the appliance and the
attachment become warm during use.
3 Start each treatment by selecting the light
intensity very carefully, based on your skin's
sensitivity and on how comfortable the
treatment feels.
Your skin may react differently on different
days/occasions for a number of reasons. See
section 'Possible side effects and skin reactions'
in this chapter for more information.
4 Press the intensity increase button to increase
the intensity. To lower the intensity, press the
intensity decrease button.
-
Every time you press the button, the
corresponding intensity light starts to flash.
This takes a few seconds.
5 Place the appliance at a 90° angle on the skin
so that the body attachment and the safety ring
are in contact with the skin.
Note: It may be difficult to have the safety ring
make proper contact with the skin on certain
areas. In that case, you could hold the Philips
Lumea Plus for men upside down, while you
press the flash button with your thumb.
25
English