RIB Vertigo Wi-Fi Series Manual Del Usuario página 16

G
B
INFRARED SIGNAL TRANSMITTER - TX
T
RANSMITTER IDENTIFICATION
Every pair of VERTIGO Wi-Fi photocells is supplied with the micro-switches
in the OFF position.
Every pair of VERTIGO Wi-Fi photocells must OBLIGATORILY be
unequivocally identified by placing only one of the 6 different micro-switches
(SWTX) on the card into the ON position.
Example: set micro-switch 1 to ON on the MASTER Wi-Fi and micro-switch 1
to ON on the VERTIGO Wi-Fi transmitter.
A
SSEMBLY OF THE INFRARED TRANSMITTER
- Separate the cover with the rubber support (1) from the base (2) and remove
the electronic board (3) (Fig. 2).
- Place the base (2) on the lower border of the leaf of the gate and fasten it
immediately using 2 self-tapping screws TCCR3,5X16 supplied (4).
- Check that the gasket is present and it is intact within the cover (1).
- If necessary, rotate the bellows assembly which includes the lens by 90°, so
to direct the infrared ray as per need (VERTIGO Wi-Fi comes with the infrared
ray set as per Fig. 2). It is possible to direct the ray according to the needs:
- Insert the electronic board (3) already mentioned, linked to the cover with
the bellow, in the special rails on the base (2).
- Insert the batteries paying attention to the polarity (Fig. 4).
- When the batteries are inserted into the transmitter the DLTX green led (Fig.
1) lights on for 10 seconds, indicating the proper functioning.
The led then switches off to avoid consuming the batteries energy, but the
transmission of the infrared signal remains active.
- Assemble the cover (1) attaching it to the base (2) on the top part using the
special tooth and then close the cover.
- Once the cover is closed, check that it is parallel to the base. Otherwise,
open it again and check that the circuit and the connection wires are
correctly fitted in their seats.
- Fasten the cover (1) to the base (2) with the 4 self-tapping screws
TCCR2,9X9,5 supplied (5).
T
RANSMITTER
SETTINGS AND
CONNECTIONS
DLTX Green LED function
indicator
SWTX Micro-switches for
coordination and
identification
BAT Alkaline batteries
2 x AA 1,5V
J1 Connector
for connecting the
transmitter diode
TX
2
16 16
16 16
TX
3
DLTX
SWTX
BAT
J1
1
+
-
4