RIB Vertigo Wi-Fi Series Manual Del Usuario página 17

INFRARED SIGNAL RECEIVER - RX
R
ECEIVER IDENTIFICATION
Every pair of VERTIGO Wi-Fi photocells is supplied with the micro-switches
in the OFF position.
Every pair of VERTIGO Wi-Fi photocells must OBLIGATORILY be
unequivocally identified by placing only one of the 6 different micro-switches
(SWRX) on the card into the ON position.
Example: set micro-switch 1 to ON on the MASTER Wi-Fi and micro-switch
1 to ON on the VERTIGO Wi-Fi receiver (the same DIP set on the
transmitter).
A
SSEMBLY OF THE INFRARED RECEIVER
- Separate the cover with the rubber support (7) from the base (8) and remove
the electronic board (9) (Fig. 6).
- Place the base (8) on the upper border of the leaf of the gate (at a maximum
distance of 3 metres from the transmitter).
- Fasten it immediately using 2 self-tapping screws TCCR3,5X16 supplied
(10).
- Check that the gasket is present and it is intact within the cover (7).
- If necessary, rotate the bellows assembly which includes the lens by 90°, so
to direct the infrared ray as per need (VERTIGO Wi-Fi comes with the infrared
ray set as per Fig. 6). It is possible to direct the ray according to the needs:
- Insert the electronic board already mentioned, linked to the cover with the
bellow, in the special rails on the base.
- Insert the batteries paying attention to the polarity (Fig. 8).
- When the batteries are inserted into the receiver the DLRX red led (Fig. 5)
lights on for 3 seconds, indicating the proper functioning.
CARRY OUT THE STORAGE PROCEDURE
AS SPECIFIED IN THE PARAGRAPH "STORAGE"
(see next page)
R
ECEIVER
SETTINGS AND
CONNECTIONS
J2 Connector
for connecting the
receiver diode
BAT Alkaline batteries
2 x AA 1,5V
SWRX Micro-switches for
coordination and
identification
DLRX Red LED indicating
correct power and
infrared signal
alignment
S3 PROG Push-button for
memorization and
alignment
RX
6
17 17
17 17
RX
-
+
7
G
B
J2
BAT
SWRX
DLRX
S3
5
8