Pride Mobility Travel Scooter Serie Manual De Instrucciones página 22

V . C O M F O R T A D J U S T M E N T S
SEAT SUSPENSION
EQUIPPED)
The seat post acts as a shock absorber and can be
adjusted for different degrees of ride comfort. Use
the setscrews that are visible through the adjustment
window on the side of the post as a guide when
making adjustments. Slide the rubber boot towards
the top of the post to expose the setscrews. See
figure 20.
To make seatpost adjustments:
1. Remove the seat from the Travel Scooter.
2. Remove the upper seat post from the Travel
Scooter by removing the detent pin from the
lower portion of the seat post, then lifting the
post straight up and off the Travel Scooter. See
figure 19.
3. Insert a 13 mm socket with an extension into the
bottom of the post. See figure 20.
4. Rotate clockwise to soften the ride or rotate
couterclockwise to stiffen the ride.
5. Reinstall the seat post and seat.
POSITIONING BELT (OPTIONAL)
Your scooter seat may be equipped with an auto-type
positioning belt that can be adjusted for operator
comfort. See figure 22 or 23. The positioning belt is
designed to help support the operator so that he or she
does not slide down or forward in the seat. The
positioning belt is not designed for use as a
restraining device.
WARNING!
should be secured at all times. Never
allow the positioning belt to hang or
drag on the floor as it may become
entangled.
To install the positioning belt (if required):
1. Remove the seat from your scooter.
2. Place the seat upside down so that you can see the
bottom of the seat base. See figure 21.
3. Use a wrench to remove the two rear bolts on the
outermost part of the seat frame.
4. Insert the bolt through the appropriate ends of the
positioning belt and then reinstall the bolts back
into the seat frame.
5. Tighten the bolts.
22
ADJUSTMENT
The positioning belt
(IF
IDENTIFICATION KEY
1. Rubber Boot
2. Setscrew
3. Ratchet Insertion Point
Figure 20. Seat Suspension Adjustment
Figure 21. Positioning Belt Bolts
1
2
3
Travel Scooter Series