Pride Mobility Travel Scooter Serie Manual De Instrucciones página 29

V I I I . C A R E A N D M A I N T E N A N C E
EXTERIOR SURFACES
Bumpers, tires, and trim can benefit from an occasional application of a rubber or vinyl conditioner.
WARNING! Do not use a rubber or vinyl conditioner on the Travel Scooter's vinyl seat or
tire tread. They will become dangerously slippery.
CLEANING AND DISINFECTION
Use a damp cloth and mild, non-abrasive cleanser to clean the plastic and metal parts of your Travel
Scooter. Avoid using products that may scratch the surface of your Travel Scooter.
If necessary, clean your product with an approved disinfectant. Make sure the disinfectant is safe for
use on your product before application.
WARNING! Follow all safety instructions for the proper use of the disinfectant and/or
cleaning agent before applying it to your product. Failure to comply may result in skin
irritation or premature deterioration of upholstery and/or Travel Scooter finishes.
BATTERY TERMINAL CONNECTIONS
Make certain that the terminal connections remain tight and are not corroded.
WIRING HARNESSES
Regularly check all wiring connections.
Regularly check all wiring insulation, including the charger power cord, for wear or damage.
Have your authorized Provider repair or replace any damaged connector, connection, or insulation that
you find before using your Travel Scooter again.
PROHIBITED! Even though the Travel Scooter has passed the necessary testing
requirements for ingress of liquids, you should keep electrical connections away from
sources of dampness, including direct exposure to water or bodily fluids and
incontinence. Check electrical components frequently for signs of corrosion and replace
as necessary.
WARNING! Do not pull on electrical harnesses directly to detach them from the scooter.
Always grasp the connector itself when disconnecting the harness to prevent wire
damage.
ABS PLASTIC SHROUDS
The shroud pieces are formed from durable plastic and may be coated with an advanced formula urethane
paint. A light application of car wax will help the shrouds retain their high gloss.
AXLE BEARINGS AND THE MOTOR/TRANSAXLE ASSEMBLY
These items are all prelubricated, sealed, and require no subsequent lubrication.
MOTOR BRUSHES
The motor brushes are housed inside of the motor/transaxle assembly. They should be inspected
periodically for wear by your authorized Provider.
CONSOLE, CHARGER AND REAR ELECTRONICS
Keep these areas free of moisture.
Allow these areas to dry thoroughly if they have been exposed to moisture before operating your
Travel Scooter again.
Travel Scooter Series
29