Crumb Pans - Blodgett MT1828 Serie Manual Del Operario

Installation
Oven Assembly
CONVEYOR
1. Slide the conveyor assembly through the left
hand tunnel opening until the sprocket is in-
side the control box. See Figure 5.
2. Install the drive belt on the motor and then
around the pulley on the conveyor assembly.
See Figure 6. Push the conveyor assembly
back to tighten the belt.
Figure 5
Figure 6
NOTE: To reverse the direction of the drive motor
(if necessary), exchange A1 and A2. See
Figure 7.
WARNING!!
Disconnect the power supply before re-
versing the drive motor.
Y OR BL
S2
S3 S1
SPEED
CONTROL

CRUMB PANS

1. Install crumb pans under each end of the con-
veyor.
6
W
AC
AC
V
L2 L1
A1 A2 A3
GND
BK
DC MOTOR
W
Figure 7
Figure 8