Crumb Pans - Blodgett SG3240 Serie Manual Del Operario

CONVEYOR BELT TENSIONER
Each tensioner installs between the idle end of the
conveyor (the side opposite the drive) and the
bracket under each conveyor support angle.
1. The belt tensioner contains a spring to adjust
the length. Compress the spring to shorten
the length of the belt tensioner.
2. Insert the pin on the end of the tensioner into
the hole in the bracket under each conveyor
support angle.
3. Expand the tensioner to engage the pin lo-
cated on the conveyor rack.
Belt
Tensioner
Figure 15
Notch
Drive Side
Crumb Pan

CRUMB PANS

1. Slide the drive side crumb pan under the con-
veyor rack from the front. The notch in the
crumb pan must line up with the drive shaft.
2. When the notch is lined up with the drive shaft,
push the crumb pan into the cooking chamber.
Hook the end of the crumb pan over the end of
the conveyor rack.
3. Slide the idle side crumb pan under the end of
the conveyor rack.
4. Slide the product stop over the end of the idle
side crumb pan.
Figure 16
17
Installation
Oven Assembly
Product Stop
Idle Side
Crumb Pan