Hoshizaki FM-1000AKE Manual De Instalación página 2

IMPORTANT
1. In order to carry out safe and proper
installation of the product, please read this
booklet carefully beforehand and follow the
instructions contained within.
2. O n c o m p l e t i o n o f t h e i n s t a l l a t i o n ,
start up the icemaker to check for any
abnormalities, and instruct the user on
how to use and maintain the icemaker in
accordance with the Instruction Manual.
3. This booklet should be handed over to the
user after the installation and be preserved
by the user together with the Instruction
Manual for any further consultation that
may be necessary.
WARNING
1. The installation must be carried out
by qualified personnel, in accordance
with current regulations, according to the
manufacturer's instructions.
2. Keep ventilation openings, in the appliance
enclosure or in the built-in structure, clear
of obstruction.
1. UNPACKING
WARNING
Children should not be allowed in reach of
the packaging elements (plastic bags and
expanded polystyrene) as they are potential
sources of danger.
CAUTION
1. Do not lift or manoeuvre the carton by
using the shipping bands.
2. Remove shipping carton, tape(s) and
packing. If packing material is left in the
icemaker, it will not work properly.
Note: T h i s i c e m a k e r n e e d s a S t o r a g e B i n .
T h e r e c o m m e n d e d S t o r a g e B i n i s
HOSHIZAKI ICE STORAGE BIN, Model
B-300SD(PD) or B-500SD(PD) with Top Kit
- 8C, B-700SD(PD) with Top Kit - 22C, or
B-900SD(PD) with Top Kit - 22C and Top Kit
- 8C.
Power Supply Cord
Top Panel
Air Filter
Louver
Front Panel
1) After removing the packaging, make sure that
the icemaker and the Storage Bin are in good
condition. If in doubt, please do not use the
equipment but apply to professionally qualified
personnel. See the instruction sheet attached to
the Storage Bin for its unpacking and installation
guidelines.
2) Remove the shipping tape holding the panels.
3) Remove the Front, Top and Side Panels. See
Fig. 2.
Front Panel
Top Panel: Remove the screw(s). Lift off.
Front Panel: Remove the screw. Lift up and pull
toward you.
Side Panel: Remove the screw. Pull slightly
toward you, and lift off.
4) Remove the package of accessories, and check
the contents:
Mounting Bracket
5) Remove the protective plastic film from the
panels. If the icemaker is exposed to the sun or
to heat, remove the film after the icemaker cools.
1
ENGLISH
Operation Panel
Louver
Fig. 1
Top Panel
Side Panel
Fig. 2
2