Briggs & Stratton Power Boss 030249 Manual Del Operario página 10

Sto_g_ the Engine
1. Turn OFF and unplug all electrical loads from
generator panel receptacles. NEVER start or stop engine
with electrical devices plugged in and turned ON.
2. Let engine run at no-load for several minutes to
stabilize internal temperatures of engine and generator.
3. Turn engine off according to instructions given in the
engine operator's manual.
4. Move fuel valve to "Off" position.
GENERATOR ADAPTER
CORD SET
The generator is equipped with a 25' generator adapter
cord set designed for a 240Volt, 30 Amp grounded neutral
circuit (Figure 5).
The maximum load on each outlet is 20Amps.The
maximum total load on both yellow wire outlets or both
black wire outlets is 30 Amps.
NOTE: Follow all safety precautions when connecting any
extension cord or device to the generator.
RECEPTACLES
[ CAUTION
1
. NEVER attempt to power a device requiring more amperage
than generator or receptacle can supply.
. DO NOT overload the generator. See "Don't Overload
Generator _.
1201240 Volt AC, 30 Amp, Locking
Receptacle
Use a NEMA LI4-30 plug with this receptacle. Connect a
4-wire cord set rated for 250VoItAC loads at 30Amps (or
greater) (Figure 6).You can use the same 4-wire cord if you
_lan to run a 120Volt load.
4-Wire Cord Set
/ --\
NEMA
LI4-30
Y (Hot)
(Neutral)
/__ X (Hot)
Ground (Green)
This receptacle powers 120/240VoltAC, 60 Hz, single
phase loads requiring up to 5,500 watts of power (5.5 kW)
at 22.9 Amps for 120Volts or 240Volts.The outlet is
protected by a push-to-reset circuit breaker.
120 Volt AC, 20 Amp,
Duplex
Receptacle
Each duplex receptacle (Figure 7) is protected against
overload by a push-to-reset circuit breaker.
@
Use each receptacle to operate 120Volt AC, single-phase,
60 Hz electrical loads requiring up to 2,400 watts (2.4 kW)
at 20Amps of current. Use cord sets that are rated for
125 Volt AC loads at 20 Amps (or greater).