Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY
Your generator
requires some assembly and is ready for
use after it has been properly serviced with the
recommended
oil and fuel.
If you have any problems with the assembly of your
generator, please call the generator heIpline at
1-800-743-4115.
If calling for assistance, please have the
model, revision, and serial number from the data tag available.
Unpacking
the Generator
I.
Set the carton on a rigid flat surface.
2.
Remove everything from carton except generator.
3.
Open carton completely
by cutting each corner from
top to bottom.
4.
Leave generator
on carton
to install wheel
kit.
Carton
Contents
Check
all contents.
If any parts are missing or damaged,
call
the generator
heIpline at 1-800-743-4115.
• The generator
• Generator
operator's
manual
• Engine operator's
manual
• Engine oil
• Three packets
of fuel stabilizer
• 30Amp
extension
cord
• Wheel
kit
Install Wheel
Kit
NOTE:
Wheel
kit is not intended
for over=the-road
use.
You will need the following tools
to install these
components:
• 2 = 13ram wrenches
• Socket wrench
with a 13mm socket
• Pliers
• Safety glasses
Refer to Figure I and install the wheel kitas follows:
I.
Tip generator
so that engine end is up.
2.
Slide axle through
both mounting
brackets.
3.
Place a wheel
on each side with air valve facing out.
4.
Place a washer
on axle and then place an e-ring in axle
groove.
S.
Install e-ring with pliers, squeezing from top of e-ring
to bottom
of axle.
CAUTION
Always wear eye protection
when installing/removing
e-rings.
Capscrew
Nut
Handle
Washer
Support Leg _QJI
Axle
Capscrew
?
i_
Nut
Wheel
E-Ring
Publicidad
Tabla de contenido
