ENGLISH
2. LOCATION
IMPORTANT
1. This icemaker is not intended for outdoor
use. Normal operating ambient temperature
should be within 5°C to 40°C. Normal
operating water temperature should be
within 5°C to 35°C. Operation of the
icemaker, for extended periods, outside
of these normal temperature ranges may
affect production capacity.
2. The icemaker should not be located next to
ovens, grills or other high heat producing
equipment.
3. The location should provide a firm and level
foundation for the equipment.
4. Allow 15 cm clearance at rear and sides
for proper air circulation and ease of
maintenance and/or service should they be
required. Allow 60 cm clearance on top to
allow for removal of the auger.
5. This appliance is not suitable for installation
in an area where a water jet could be used
and where dripping is not allowed.
6. D o n o t p l a c e a n y t h i n g o n t o p o f t h e
icemaker or in front of the louver.
3. INSTALLATION
* Incorrect installation can cause harm to people,
animals or things, for which the manufacturer
cannot be held responsible.
[a] STORAGE BIN
1) Fully screw in the four legs provided (bin
accessory) into the storage bin underside. See
Fig. 3.
Bottom Plate
Adjustable Legs
2) P o s i t i o n t h e s t o r a g e b i n i n t h e s e l e c t e d
permanent site.
3) Place the icemaker on top of the storage bin by
holding the bottom.
4) Secure the icemaker to the storage bin, by
using the two mounting brackets and two bolts
provided. See Fig. 4.
Bolt
5) Seal the seam between the icemaker and the
storage bin with food grade sealant.
6) Refit the side panels in their correct position.
7) Adjust the four legs on the bottom (adjustable
from 0 to 25.4 mm) to have the icemaker
perfectly horizontal. Use the spirit level. See Fig.
5.
[b] MULTI COMPRESSOR RACK SYSTEM
Use an appropriate condensing unit such as:
FM-1200ALKE(-N)
OP-LCHC068NTA02 by DANFOSS
Evaporating temperature: -25°C 2830W
FM-1800ALKE(-N)
OP-LCHC108NTA02 by DANFOSS
Fig. 3
Evaporating temperature: -25°C 4300W
When the condensing unit operates for more than
one icemaker, install a ball valve on the liquid line
and suction line.
2
Icemaker
Bin
Mounting
Bracket
Adjust legs
Fig. 4
Fig. 5