After Installation - LUCCI Air AIRFUSION GIRONA Manual De Instrucciones

Airfusion Penta Installation Instructions
WINTER Mode: The reverse switch shall be in the "up" (WINTER) position to make the fan rotate in a
clockwise direction. The airflow will be directed upwards assisting in the circulation of warm air, for energy
conservation in winter.
Fig. 11
Reverse Switch

AFTER INSTALLATION

WOBBLE:
NOTE: CEILING FANS TEND TO MOVE DURING OPERATION DUE TO THE FACT THAT THEY ARE
MOUNTED ON A RUBBER GROMMET. IF THE FAN WAS MOUNTED RIGIDLY TO THE CEILING IT
WOULD CAUSE EXCESSIVE VIBRATION. MOVEMENT OF A FEW CENTIMETRES IS QUITE
ACCEPTABLE AND DOES NOT SUGGEST ANY PROBLEM.
TO REDUCE THE FAN WOBBLE: PLEASE CHECK THAT ALL SCREWS WHICH FIX THE MOUNTING
BRACKET AND DOWN ROD ARE SECURE.
BALANCING KIT: A balancing kit is provided to balance the ceiling fan on initial installation. Please refer
to the instruction on how to use the balancing kit. The balancing kit can be used to assist re-balancing
should the ceiling fan become un-balanced again. Store your balancing kit away after installation for future
use if required.
NOISE:
When it is quiet (especially at night) you may hear occasional small noises. Slight power fluctuations and
frequency signals superimposed in the electricity for off-peak hot water control, may cause a change in fan
motor noise. This is normal. Please allow a 24-hour "breaking -in" period, most noises associated with a
10 | P a g e V e r 1 . 0