Communication; Interface Commands - OHAUS Adventurer AX124 Manual De Instrucciones

ADVENTURER BALANCES
9.4

Communication

9.4.1

Interface Commands

Commands listed in the following table will be acknowledged by the balance.
The balance will return "ES" for invalid commands.
Command
Characters
IP
P
CP
SP
SLP
SLZP
xP
0P
H
Z
T
xT
PT
ON
OFF
C
IC
AC
PSN
PV
x#
P#
x%
P%
xS
xRL
Find Quality Products Online at:
TABLE 9-6. ADVENTURER INTERFACE COMMAND LIST
Function
Immediate Print of displayed weight (stable or unstable).
Print displayed weight (stable or unstable).
Continuous Print.
Print on Stability.
Auto Print stable non-zero displayed weight.
Auto Print stable non-zero weight and stable zero reading.
Interval Print x = Print Interval (1-3600 sec) 0P ends interval Print
See above
Enter Print Header Lines
Same as pressing Zero Key
Same as pressing Tare Key.
Establish a preset Tare value in displayed unit. X = preset tare value. Sending 0T clears tare (if
allowed).
Prints Tare weight stored in memory.
Brings out of Standby
Goes to Standby.
Begin Span Calibration
Begin internal Calibration, same as trigger from calibration menu.
Abort Calibration. Attention: when LFT ON, the operation is not allowed.
Print Serial Number.
Print terminal software version, base software version and LFT ON (if LFT is set ON).
Set Counting APW (x) in grams. (must have APW stored)
Print Counting application APW.
Set Percent application reference weight (x) in grams. (must have reference weight stored)
Print Percent application reference weight.
0 = print unstable data, same as IP; 1 = print stable only
0 = disable response; 1 = enable response. This command only controls the "OK!" response.
GlobalTestSupply
www.
1)
, same as SP.
.com
sales@GlobalTestSupply.com
EN-55