Installing With Base; Installing With Stroller - Jole juva Manual De Instrucciones

ii. Installing with Base
1. Unfold the load leg from storage compartment.
2. After placing the base on the vehicle seat, squeeze load leg
adjustment button to extend the load leg to floor
the load leg indicator shows green means it is installed
properly, red means not.
!
The load leg has 8 positions, the load leg indicator shows
red means the load leg is in a wrong position.
!
Make sure the load leg is secure by pressing down on
the front of the base.
3. Open the lock-off and route the vehicle safety belt through
the belt path (Fig. 27.1), and lock it into the buckle
4. Tension the vehicle safety belt as much as possible while
pushing down on the base, and check it is not slack or
twisted. Close the lock-off.
!
Check the safety belt does not move by pulling and
pushing hard on base. If belt loosens or lengthens,
repeat procedure.
The installed base is shown as
!
Please ensure that there is no gap between the seat and
the bottom of the base.
!
The safety belt must go under the lock-off
not over the lock-off.
5. Push the child restraint down into the base
child restraint is secure, the child restraint indicator shows
green, or else shows red.
!
Pull up on the child restraint to be sure it is securely
latched into the base.
23
(Fig. 25)
(Fig.
(Fig. 26.2)
(Fig.
(Fig. 27.3)
Fig. 28
(Fig.
(Fig. 28.2)
(Fig. 29), if the
(Fig. 30)
!
The child restraint can not be used if the vehicle safety
belt buckle (female buckle end) is too long to anchor the
base securely.
6. To release the child restraint, pull the child restraint up while
squeezing the child restraint release button.
26.1),
iii. Installing with Stroller
Your infant child restraint is designed to attached to certain joie
stroller models featuring a special tray, armbar or calf support.
!
Please make sure your stroller can fit the infant child
restraint before purchasing it.
27.2).
!
Never allow more than one baby in the travel system
at one time.
!
Please brake your stroller before assembling the
infant child restraint.
!
Check the parts that are used to fix the infant child
restraint are securely fastened on the stroller.
!
Recline the stroller seat back to the lowest position.
To assembling the infant child restraint on Joie strollers,
please follow these steps:
28.1),
1. Place child restraint into stroller so notches in rockers fit
over edge of armbar, tray or calf support. The child restraint
will then automatically click into place.
( Fig. 32 & 33 & 34 & 35)
!
If armbar has fabric cover, please detach the velcros on
armbar cover first.
!
For the stroller with a special calf support, please adjust
the calf support to the vertical position, detach the
velcros, and then lift the fabric cover.
(Fig. 30.1)
(Fig. 31)
(Fig. 34.1)
(Fig. 35.1)
24