Introduction; Safety - Enerpac S Serie Hoja De Instrucciones

1

Introduction

Enerpac S-Series
The Enerpac S-series of lightweight
hydraulic wrenches have been designed to
tighten and loosen nuts and bolts for
professional applications. The tool has an
interchangeable drive shaft for which a
wide range of socket sizes are available.
The adjustable reaction arm further
enhances the flexibility of the tool.
The tool easily connects to the range of
available Enerpac pumps. Enerpac can
supply air, electric or hand operated
pumps.
Delivery instructions
Upon delivery all components must be
inspected for damage incurred during
shipping. If damage is found the carrier
should be notified at once. Shipping
damage is not covered by the Enerpac
warranty.
Warranty
• Enerpac guarantees the product only
for the purpose for which is intended.
• All Enerpac products are guaranteed
against defects in workmanship and
materials for as long as you own
them.
Any misuse or alteration invalidates the
warranty.
• Observe all instructions as laid down
in this manual.
• Replace any parts with Enerpac spare
parts only.
CE Declaration of conformity
S1500/S3000/S6000/S11000/S25000
4
Enerpac declares that these models meet
the applicable standards and directives
issued by the European Community.
For a detailed list refer to the separate
certification sheet.
2

Safety

Be aware that the operator is fully
responsible during the operation of this
tool. Enerpac is not responsible for
damage or injury caused by misuse of this
tool. Under some circumstances additional
safety requirements may be required.
Contact Enerpac immediately if a
potentially hazardous situation arises.
Read this manual carefully and observe all
safety precautions.
- Make sure you have completed a
safety induction training, specific to
the work surroundings. The operator
should be thoroughly familiar with the
controls and the proper use of the
tool.
- The operator must be at least 18
years of age.
- Always wear protective headwear, ear
protectors, footwear and gloves (at a
minimum rigger type gloves) suitable
for safe operation of the tool. The
protective clothing must not interfere
with safe operation of the tool or
restrict the ability to communicate
with co-workers.
- Make sure your workplace is safe.
- Do not place any part of the body
between the reaction arm and the
reaction point.
- Do not place any objects between the
reaction arm and the reaction point.
Keep the hoses away from the
reaction points.