Enerpac S Serie Hoja De Instrucciones página 7

1
Fig. C
11
Fig. D
3.4
3.4.1 To fit a hex socket
•
•
10
3.4.2 To remove a hex socket
9
•
•
3.5
The reaction arm can be rotated
incrementally through 90˚, which will
maintain stability against a reaction point
up to full torque.
•
•
6 7
•
To fit and remove a hex socket
(fig. C)
Position the socket (9) onto the drive
shaft (1).
Fit the retaining pin (10).
Remove the retaining pin (10).
Take the socket (9) off the drive shaft
(1).
To mount the reaction arm (fig. D)
Position the reaction arm (6) onto the
ratchet end (11) of the tool.
Press the latch (7) and slide the arm
all the way onto the tool. Release the
latch to secure the arm.
To adjust the angle of the reaction
arm (6), press the latch (7) and slide
the arm off the tool. Position the arm
as necessary.
7