Bosch LTC 8780 Serie Manual De Instrucciones página 28

14 en | TYPICAL APPLICATIONS
3.
Switch
BAUD
CODE DIST
ADDR FUNCT
RCVR DRVR
XPOINT
CCL
MATCH
ADDRESSES
MODEM CMD
ORIGINATE
CHECK CTS
4.
Switch
BAUD
CODE DIST
ADDR FUNCT
RCVR DRVR
XPOINT
CCL
MATCH
ADDRESSES
MODEM CMD
ORIGINATE
CHECK CTS
If connecting to an Allegiant system, be sure to configure the Allegiant system's CONSOLE
port with handshaking turned OFF.
F01U066145 | 1.0 | 2007.04
TRANSMIT ONLY RECEIVER/DRIVER COMMANDS FOR 1 BLOCK OF 64 CAMERAS
(Figure 5.3 on page 20).
Setting
Set to the desired baud rate; see Table 1.
X for transmitter; OFF for receiver
ON for transmitter; X for receiver
ON
OFF
OFF
ON for transmitter; OFF for receiver
For transmitter, configure to the desired
block of 64 cameras; refer to Table 5; X for
receiver
Refer to DIP switch S105 settings section
Refer to DIP switch S105 settings section
Refer to DIP switch S105 settings section
SATELLITE SELECTOR UNIT CONFIGURATION (Figure 5.4 on page 22).
Setting
Set to the same baud rate as the Allegiant
System Console interface, according to
Table 1.
X
OFF
OFF
OFF
ON
ON
Configure to match the Satellite Address,
see Table 4.
OFF
X
ON
Instruction Manual
LTC 8780 Series
Bosch Security Systems, Inc.