Bimar VP411 Manual De Instrucciones página 11

• If the appliance breaks or there is a malfunction,
switch off the appliance and have it checked by
qualified
unauthorised personnel may be dangerous and
nullify the guarantee.
• Ensure that the fan is switched off from the supply
mains before removing the guard.
INSTALLATION
• After removing the packing materials, check the integrity of the appliance; if you are
unsure, do not use it and ask for qualified professional help. The packing materials (plastic
bags, polystyrene, nails, etc.) must be kept out the reach of children because they are
potential sources of danger. Note: any stickers or advertising material applied to the grille
must be removed before using the appliance.
• Before connecting the appliance, check that the voltage indicated on the data plate
correspond to those of the electricity network. In the event of incompatibility between
the plug point and the plug of the appliance, have the plug replaced with q suitable one
by professionally qualified personnel, who will make sure that the section of the wires of
the outlet is suitable for the power drawn by the appliance. In general, the use of adapters
or extension cords is not recommended; if their use is necessary, they must conform to
existing safety standards and their current capacity (amperes) must not be less than the
maximum of the appliance.
• Before each use, check that the equipment is in good condition, that the power cord is not
damaged: if in doubt consult a qualified professional.
• The power socket must be easy to reach so the plug can be removed quickly in case of
emergency.
• Keep the appliance away from:
heat sources (e.g. open flame, gas stove, etc.)
-
liquid receptacles (e.g. sinks, etc.) to avoid water splashing onto the appliance or it
-
falling in (minimum distance of 2 meters)
fabrics (curtains, etc.) or floating materials that could obstruct the air intake grille;
-
make sure that the front is free of floating materials (dust, etc.).
• The appliance must not be used in dusty environments or in the presence of floating
materials or used in a room where there is a fire risk.
• Stand the appliance on a smooth, horizontal surface or table; do not place it on a inclined
surface (the appliance could fall over).
ASSEMBLY
Warning: before assembling the fan ensure that it has been disconnected from the mains.
Refer to the following diagrams for assembly and proceed as follows:
1) Base. Comprising:
4 supports (7) with sliding joint and fastening clip
-
tube (9) and adjustable extension tube (10), and support recesses (5).
-
Push each support fully into its recess, until the clip slots into place (see fig.1-2).
personnel; repairs carried
11
out by