HoMedics BPA-060 Manual Del Usuario página 16

1. If the cuff is not assembled, pass the end of the
cuff furthest away from the tubing through the metal
D-ring in order to form a loop. The smooth side without
the felt material should be on the inside of the cuff loop.
End of cuff
D-ring
2. Plug the cuff tube into the left side of the unit.
Insert plug here
3. Open the arm cuff so that your arm may be placed
through it.
4. Remove tight fitting clothing from your upper left arm
so that the cuff can be wrapped around your exposed
arm.
5. Position cuff edge 0.8-1.2
inches (2-3 cm) above elbow.
15
6. Cen
7. Pul
eve
and
Allo
the
8. Lay
so
hea
Note:
• The
wou
• If it
can
me
• To u
sym
arte
(2 c
elbo
righ
puls
This