Potential For Electromagnetic Interference - HoMedics BPA-060 Manual Del Usuario

POTENTIAL FOR ELECTROMAGNETIC
INTERFERENCE
To avoid inaccurate results caused by electromagnetic interference
between electrical and electronic equipment, do not use the device
near a cell phone or microwave oven.
For most wireless communication devices, it is
recommended to maintain a distance of 10.8
feet (3.3m) in order to avoid electromagnetic
interference.
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any
interference received, including interference that
may cause undesired operation.
NOTE: The manufacturer is not responsible for any radio or TV
interference caused by unauthorized modifications to this equipment. Such
modifications could void the user authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
27
ELEC
• This mo
to purch
• Guidanc
The dev
in such
Emission
RF emiss
RF emiss
Harmonic
61000-3-2
Voltage fl
emission
• Guidanc
The dev
in such
Immunity
Electrosta
discharge
IEC 6100
Power fre
(50/60 Hz
magnetic
IEC 6100
Electrical
transient/
IEC 6100
Surge
IEC 6100
interrupti
and volta
variations
power su
input line
IEC 6100