Nuova Simonelli APPIA II V 2GR Manual Del Usuario página 43

7.5
PROGRAMMING
STANDARD DOSES
4 group doses and water (steam).
To do this, it is necessary to press the key
and hold it down for at least 10 seconds
until the flashing keys switch off.
The doses are:
1CN 2CN 1CL
40 cc 60 cc 50 cc
WATER
9 sec.
NOTE: A time setting of 0 seconds for steam
and water means this function will work
continually.
7.6
COPYING DOSE
SETTINGS
It is possible to copy the dose settings for
group 1 to groups 2 or 3.
To do this, hold down the continuous key
of the group 2 or 3 for at least 8
seconds until the keys stop flashing.
7.7
PROGRAMMING
OPERATING
PARAMETERS
The adjustments listed here below must
ONLY be performed by a Specialist Technical
Engineer
If you hold down the
group, after first entering the programming
2CL
mode for the first group, this will access the
85 cc
machine parameters setting mode; this is sig-
nalled by the continuous key
second group, which will switch on.
1. Enabling the pump if the level is enabled.
2. Enabling the software block to enter the
dose programming function.
3. Adjusting keypad brightness.
4. Enabling the hot water pump (on machines
fitted with economiser).
5. Disenabling the cup warmer
6. Restoring default settings.
1. Enabling the pump during levelling.
Use the espresso key
enabling during levelling:
if the key
together with the level; if it is switched off, the
pump is not enabled with the level function.
2. Enabling the software block to enter the
Use the long coffee key
software block to programme doses (key lit) or
CAUTION
to de-activate the block (key off).
3. Adjusting keypad brightness..
The 2 long coffees key
group is used to choose the key brightness set-
ting from 5 pre-set levels.
key of the second
Use the
change the level, lowering it to minimum or
returning it to maximum.
for the
4. Enabling the hot water pump (machines
Use the hot water key
to switch on while hot water is being delivered.
If the
while hot water is being delivered; if it is
switched off, the pump will not switch on.
5. Disenabling the cup warmer.
to set pump
Use the
is lit, the pump is enabled
warmer operation. If the key is lit, the cup
warmer will operate normally as set during
programming; if the key is switched off, the cup
warmer is disenabled.
dose programming function.
of the second
key, which will flash, to
fitted with economiser only).
to set the pump
key is lit, the pump will switch on
key to enable or disenable cup
to enable a
39