Allmatic MINIART R Manual Del Usuario página 14

FIXING THE OPERATOR TO THE PILLAR (D)
In order to carry out a proper installation of the operator, it is necessary to comply with the geometry measurement shown in the tables in Pic. 6 and 8.
X
138
80
80 98
D
ASSEMBLING DRIVE ARM WITH THE ANTI-THEFT
LOCKING DEVICE (E)
Assemble the arms as shown in Pic. 5.
Caution: Once the screws V and W have been thoroughly
tightened (Pic. 5) unscrew them for half a turn, in order
to guarantee a free movement of the arm.
After assembling the arm, unlock the motor and fix
the arm to the motor with the supplied screw and M8
washer.
With the gate in closing position and the motor at rest,
the anti-theft lock (E) keeps the gate leaves securely
closed and prevents anybody from forcing the gate leaves
open.
FIXING THE DRIVE ARM WITH THE ANTI-THEFT LOCKING DEVICE (E) Unlock the operator.
Caution: start the operation with the gate in closing position. Straighten the levers until the anti-theft lock (E Pic. 5) is engaged and stressed. Move
the levers back a little bit just enough to avoid keeping the anti-theft locking in working position (stressed) every time the gate will close.
a° A max A max*
90 140 190
90 200 200
90 205 205
90 225 225
90 - 240
95 0 0
100 0 0
105 0 0
110 0 0
14/20
13
WARNING! Check with the specific tool (level) that the motor lever is correctly installed
and maintains a perfectly horizontal position throughout the stroke.
X B I T sec
60 130 300 20
70 140 270 19
80 150 230 18
90 160 135 16
110 180 0 15
70 140 284 18
90 160 302 19
110 180 315 19
155 225 322 19
FRA ENG
E
B
X
A
I
ESP ITA DEU
6-1624105
V
DRL8x17I
DRL10x20I
DRG6I
DRL8x17I
α
rev. 6 19/03/2018
4
W
DRL8x17I
5
6