Safety Recommendations - Equipment; Check List: 7 Steps Before Start - Pecol RB2600PROHP-230 Manual De Instrucciones

3.3. Safety Recommendations - Equipment

• Disconnect the machine from the electrical plug before any intervention.
• Select the correct electric tool taking into account the type of use and power required.
• Do not change or make adjustments that change the original configuration of the
power tool.
• Use only recommended and quality discs (see page 59).
• Check if the disc is in good condition, without defects.
• If you intend to cut wood, use specific wood discs, which are designed for use on angle
grinders.
Never adapt a circular saw disc (A) or a disc with chains
(B) for wood, on a grinder. Risk of serious injury.
• Always operate with the protective guard and positioned to protect the user.
• Always use the auxiliary handle. This will give more control and safety to the use.
• Inspect cables and plugs for cracks, parched parts, lack of insulation and keep them
clean and free of oils and greases, which can deteriorate the insulation.
• Only use certified cables and plugs with EC marking and with supported power (in
watts) greater than the sum of all equipment connected to it.
• Never pull the plug or hold the machine by the cable.

3.4. Check List: 7 steps before start

1. Be aware of the safety recommendations in the manual.
2. Check the general condition of the machine. Look for cracks, clearances, loose parts
inside, misalignments, interference in the angle grinder movement, among others and
check electrical cables.
3. Check if the auxiliary handle is securely fastened.
4. Check the switch movement.
5. Check if the disc is suitable for the angle grinder (size, speed, central hole) and for
the work to be performed and is in good working condition (without fissures, cracks,
deformations, etc.) and is installed correctly. Some types of discs have a specific side of
the face for affixation.
6. Check if the available mains voltage (volts, Hz and alternating current) is compatible
with the machine specification.
7. If the disc is new, test it with the grinder for 1 minute in an isolated area. If it is
damaged, it can become fragmented.
P.50
PT ES EN FR
A B