How To Install The Protection Guard; Deburring And Thinning Operation - Pecol RB2600PROHP-230 Manual De Instrucciones

3.7. How to install the protection guard

1. The guard should be positioned so as to
protect the user and persons from particles,
sparks and possible projections of pieces of the
disc.
2. Once adjusted in the desired position, tighten
the fast set screw so that the guard can not be
moved by hand.

3.8. Deburring and thinning operation

• When powering up, wait until the machine reaches maximum speed before starting
work.
• Tilt the angle grinder according to the needs of the work, within the recommended
angles. Make sure that the workpiece is securely fastened.
• Do not apply too much pressure. A decrease in rotation worsens the result and the
efficiency of the roughing work. Do not generate excessive heat on the disc and the part.
Make stops.
• Hold the grinder firmly and, with proper posture, apply circular movements back and
forth.
• Always use both hands, and with the auxiliary handle installed.
If, despite maintaining the correct tilt, the work starts having poor performance, it is a
sign that the disc is worn out or a higher power is required.
Wait for the machine to immobilize the movement before lowering or put it down.
Clamping level
FR EN ES
P.53
PT