Troubleshooting Chart - Pecol RB2600PROHP-230 Manual De Instrucciones

4.5. Troubleshooting Chart

In case of problems not mentioned or of problems that you can not solve, contact our
Technical Assistance Service PECOL (page 56).
PROBLEM
The power tool will not start
Low performance of the power
tool
Irregular operation (stop - start
- stop ...)
Gearbox heats too much
The power tool body becomes
too hot
POSSIBLE CAUSE
Power failure
Worn carbon brushes. The brushes
lose their function when they are
only 5 mm.
The circuit breaker on the power
supply board was started.
Switch damaged.
Inadequate electrical extension.
Electric extension coiled.
Inadequate electrical network.
Power tool wires or an extension
cable (if applicable) broken.
Lack of lubricant /
lubricant deteriorated.
Machine in overload.
Lack of ventilation.
Bearings damaged.
Power supply voltage drop.
SOLUTION
Connect other electrical equipment
to the plug and check if it works.
Replacing the brushes (page 55).
Check if the cause is a short circuit
in the tool, its wire or the extension
or plug.
Refer to PECOL Technical
Assistance Service.
Check the total permissible power
of the extension. Use a wired
extension of larger diametre
(section), which supports the
required power.
If it is a winding extension, it loses
power when it is coiled. Uncoil.
Check if the voltage, frequency and
type of the mains is suitable for the
power tool.
If you are using a generator or
transformer, it is recommended an
output power of at least twice than
required for the power tool and a
rated voltage variation of at most
5% and at least 15%.
If the power cable of the power tool
is damaged, it must be replaced. If
it is a defective extension, replace
it.
Refer to PECOL Technical
Assistance Service.
Decrease working pressure.
Clear the air passages.
Refer to PECOL Technical Service
for replacement.
Check mains voltage and
extension.
FR EN ES
P.57
PT