Initial Settings; Adjusting Initial Settings; Setting The Time - Pioneer Super Tuner III DEH-P4400 Manual Del Usuario

Section

Initial Settings

07

Adjusting initial settings

Initial settings lets you perform initial set up of
different settings for this unit.
1 display
FUNCTION
Shows the function status.
1 Press
SOURCE
off.
2 Press
FUNCTION
appears in the display.
3 Press
FUNCTION
settings.
Press
FUNCTION
the following settings:
— —
TIME WARN
Use the following instructions to operate each
particular setting.
• To cancel initial settings, press
• You can also cancel initial settings by holding
down
FUNCTION
32
En
1
and hold until the unit turns
and hold until
TIME
to select one of the initial
repeatedly to switch between
— —
AUX DIMMER FRT+REAR
BAND/ESC
until the unit turns off.

Setting the time

This is used to set the time on the unit's clock
display.
1 Press
FUNCTION
Press
FUNCTION
display.
2 Select the portion of the time display you
wish to set with 2/3.
Pressing 2/3 will select a portion of the clock
display:
—
HOUR MINUTE
As you select portions of the clock display the
portion selected will blink.
3 Select the correct time with 5/∞.
Pressing 5 will increase the selected hour or
minute. Pressing ∞ will decrease the selected
hour or minute.
.
to select the time.
until the time appears in the