Bottom Inputs And Outputs - Tivoli Audio NetWorks Manual Del Propietário

Note: Some MP3 players, including the iPod, use dedicated software to playback music and
to charge, and therefore won't be recognized by the NetWorks radio. In these cases, when such
a device is connected to the USB input, the LCD will briefly show "USB unsupported" and might
not charge. To play these MP3 players, including the iPod, connect the player's headphone
output to the NetWorks Auxiliary input and charge the device (if necessary) through other means.
If a Real music file will not play, it should be converted to MP3, WMA, or AAC format for play-
back through the NetWorks.
6. PRESETS #1-5, SOURCE, MENU/SELECT, pq/tu: See "Guide to Features (Remote Control)".
Guide to features (Bottom):
8
6
5
4
1. 12VDC/1A: Connect an optional external power supply to this input, or use an optional 1A
fused, 12VDC adaptor for operation in a boat or camper. The connector must be 5.5mm/2.1mm
center positive. It is normal for the external power supply to become warm during use. This
input should never be used simultaneously with the power cord input.
2. AUX IN: To hear audio from another device such as a CD or MP3 player, connect said device's
audio output to this 3.5mm female stereo input. Note: You may need to adjust the volume
level differently for an auxiliary device than the level used for radio listening.
3. MIX IN: Connect the audio output from a computer to this 3.5mm female stereo input. The
computer's audio will be mixed in with the audio from whatever source the NetWorks is in.
The volume level of the computer's audio is controlled by the computer.
4. SUB OUT: Connect one end of the audio cable included with Tivoli Audio's Model Subwoofer
(not included) to this 3.5mm female output.
5. REC OUT: To record from the NetWorks, connect the inputs from a recording device (such as
a cassette deck) to this 3.5mm female stereo fixed output.
6. ETHERNET: If a WiFi signal is unavailable or is unreliable, securely connect a standard Ethernet
cable (not included) to this input.
7. R-SPR: Connect the male RCA from the optional NetWorks Speaker to this female RCA output,
adjust the Balance control to the center detent position, and place the Mono/Stereo switch in the
Stereo position. Bend the NetWorks Speaker connecting cable so the NetWorks radio sits flush.
8. POWER CORD INPUT: Insert the correct end of the included power cord securely into this
input and connect the other end of the cord into an electrical outlet. Damage as a result of
using the NetWorks with an incorrect voltage is not covered by the factory warranty.
Helpful hint: When connecting mini cables (not included) to the bottom inputs and outputs, bend
the cables so the NetWorks sits flush.
Be sure the NetWorks is turned off when connecting/disconnecting audio cables.
12VDC
ETHERNET
1000mA R-SPR
SUB OUT REC OUT MIX IN AUX IN
English
1
7
3
2
11