Tivoli Audio NetWorks Manual Del Propietário página 7

connection (Ethernet)*, or set up the wireless configuration manually. Use pq buttons on
the remote control to highlight the network you want and then press Select. The display will
show "Connecting". After connecting you may begin using your NetWorks.
*If you prefer to connect using a direct Ethernet cable, connect the cable (not included) to the
Ethernet input located on the bottom of NetWorks.
7. If you are prompted to enter a password, your network uses a security encryption system.
You must enter the correct code to allow NetWorks to communicate with your network.
The codes are case sensitive so be sure to enter the code exactly as it is configured in your
wireless network. Use the pq buttons to change character pages. Use the tu buttons to
highlight characters and the Select button to enter the character. After you've selected all the
characters for your password, press the '
a) the '<' symbol = back space if you make an error
b) the '
c) the 'C' symbol = cancel process and return to previous menu
When selecting a blank space it will be represented by a blank space
followed by an underscore indicating the position of the next character.
NetWorks will now connect to your network.
If the NetWorks fails to connect with the first attempt and you are sure you entered your password
correctly, press the '
over again.
If your network uses an encryption system, Tivoli Audio strongly advises against turning it off. You
should maintain proper security of your network. If several networks are available, you should
connect only to the network you have an agreement to use.
If you experience difficulty connecting to your network, consult our website (http://tivoliportal.com)
or contact your dealer/distributor for further assistance.
Should you ever need to manually initiate a network scan you can do so by entering the "Internet
Setup" menu and selecting "Scan NetWorks". The "Internet Setup" menu will also allow you to
view and edit current settings.
Wired/Wireless connection: When changing from wireless to wired, after connecting the Ethernet
cable to the input on the bottom of your NetWorks radio, enter the "Internet Setup" in the menu,
access the "Manual Settings" option and select "Wired". Be sure the cable is connected first before
switching to Wired mode. The wireless connection is now disabled and no signal strength will be
shown on the display. When changing from wired to wireless, rather then select "Wireless", select
"Scan for NetWorks" in the "Internet Setup" menu and pick up from Step #6 under "Getting Started".
WiFi Signal Reception: The WiFi antenna is incorporated inside the NetWorks. Locate the
NetWorks for best WiFi signal reception. Reception can be affected by your home's type of
construction as well as other causes of interference. In Internet radio and music player modes
the display will show WiFi signal reception in the lower right corner. This will not be shown when
using an Ethernet cable. Note: WiFi NetWorks can sometimes impart very low level random noise
into the audio signal. This is not a fault of the NetWorks radio.
' symbol = enter completed password
' symbol to repeat the connection rather than re-enter your password all
' character to enter your password.
English
7