Nice Era Mat VS Instrucciones Y Advertencias Para La Instalación Y El Uso página 11

6.C - Programming the manoeuvre the motor should perform automatically when the rain
sensor signals the "presence of rain"
Before starting the procedure, move the awning to the mid-point of its stroke.
01. Keep the n key pressed and wait for the motor to perform 2 movements. Upon completion, release the key.
02. Keep the t key pressed and wait for the motor to perform 3 movements. Upon completion, release the key.
03. Keep the n key pressed and wait for the motor to perform 2 movements. Upon completion, release the key.
04. • To program the awning/shutter to be raised, if it starts to rain: keep the s key pressed and wait for the motor to perform 3 movements.
Upon completion, release the key.
• To program the awning/shutter to be lowered, if it starts to rain: keep the t key pressed and wait for the motor to perform 3 movements.
Upon completion, release the key.
01
5
sec.
=
=
Note – When performing the procedure, you can cancel it at any time by keeping the n and t keys pressed simultaneously for 4 seconds. Otherwise, do not press
any key and wait 60 seconds for the motor to perform 6 movements.
6.D - Adjustment of "Wind" climate sensor
At the factory, the intervention threshold to is set at level 3 and to change it you must take the following steps:
01. Keep the n key pressed and wait for the motor to perform 2 movements. Upon completion, release the key.
02. Keep the t key pressed and wait for the motor to perform 3 movements. Upon completion, release the key.
03. Briefly press the s key a few times, depending on the level you want to set for wind threshold:
1 press = wind at 5 Km/h
2 presses = wind at 10 Km/h
3 presses = wind at 15 Km/h (factory settings)*
4 presses = wind at 30 Km/h
5 presses = wind at 45 Km/h
After about 10 seconds, the motor performs the number of movements indicated by the level number selected. Note – If this does not occur, cancel the proce-
dure. this way, the adjustment is completed without changing the factory setting.
04. Keep the n key pressed and wait for the motor to perform 3 movements. Upon completion, release the key.
01
5
2
sec.
03
x 1 = wind at 5 Km/h x 1 = vento a 5 Km/h
x 2 = wind at 10 Km/h x 2 = vento a 10 Km/h
x 3 = wind at 15 Km/h (*) x 3 = vento a 15 Km/h (*)
0,5
x 4 = wind at 30 Km/h x 4 = vento a 30 Km/h
sec.
x 5 = wind at 45 Km/h x 5 = vento a 45 Km/h
Note: • When performing the procedure, you can cancel it at any time by keeping the n and t keys pressed simultaneously for 4 seconds. Otherwise, do not press
any key and wait 60 seconds for the motor to perform 6 movements. • If you use a sensor equipped with a "trimmer", you must read the sensor instructions and ad-
just the threshold directly on the sensor.
02
2
04
5
3
sec.
04
5
3
sec.
02
5
sec.
10
sec.
5
3
sec.
3
04
1 /
2 /
3 /
4 /
?
5 /
03
5
2
sec.
5
3
sec.
English – 10