Avid Elixir Manual Del Usuario página 3

English
1
install rotor
Mount the rotor to the hub using the supplied T-25 TORX® bolts and tighten
to 6.2 N•m (55 in-lb). Avid logo MUST face out. Install the wheel into the fork
or frame.
2
MoUnt front caliPEr
Mount the front caliper (shorter hose) to the fork.
i.s. MoUnt
Torque bolts to:
9-10 N•m (80-90 in-lb) Loosen before
mounting
i.s. MoUnt
Loosen the CPS bolts, then bolt the caliper to the mounting
tabs. Tighten the mounting bolts to 9-10 N•m (80-90 in-lb).
Check that the caliper moves freely on the CPS hardware.
4
Elixir User Manual
Torque bolts to:
6.2 N•m (55 in-lb)
Post MoUnt
or
Remove...
...then mount direct
Snug, then back off
1/8th to 1/4th turn
Post MoUnt
Remove the mounting bracket but leave the CPS bolts and
washer stacks intact. Bolt the caliper directly to the fork.
Snug the bolts, then back them out 1/8th to 1/4th turn.
Check that the caliper moves freely on the CPS hardware.
95-5015-016-000 Rev B
Elixir User Manual
3
MoUnt rEar caliPEr
Loosen the CPS bolts, then mount the rear caliper (longer hose) to
the I.S. tabs on the rear of the bike. Tighten the mounting bolts to
9-10 N•m (80-90 in-lb). Check that the caliper moves freely on the
CPS hardware.
Torque bolts to:
9-10 N•m (80-90 in-lb)
4
adJUst hosE anglE, thEn roUtE
(Elixir cr Mag/Elixir cr/Elixir r)
If necessary, slightly loosen the banjo bolts on the caliper with an
8 mm open-end wrench and rotate the fittings for optimal routing.
Re-tighten the banjo bolts to the specified torque, then route the
hose. Make sure there is enough hose at critical points to allow
for suspension movement, but also make sure there aren't any big
loops of extra hose. Now, secure the hose to the frame or fork.
Copyright © 2009 SRAM, LLC
English
Loosen before
mounting
Re-torque to:
5.5-6.2 N•m
(50-55 in-lb)
5