Avid Elixir Manual Del Usuario página 4

English
5
MoUnt lEvEr (Elixir cr Mag)
The Elixir CR Mag lever can be mounted to the handlebar one of
two ways:
A. Use a T-25 TORX to loosen the clamp bolt and slide the
lever over the end of the handlebar to the desired position.
Tighten the clamp bolt to 5-6 N•m (43-52 in-lb).
B. Use a T-25 TORX to remove the clamp bolt and clamp
face. Slip the clamp over the handlebar. important: do not
spread the clamp any more than is necessary to slip
it over the bar. Slide the lever into the opening between the
clamp and handlebar and reinstall the clamp bolt. Place the
lever in the desired position and torque the bolt to
5-6 N•m (43-52 in-lb).
MoUnt lEvEr (Elixir cr/r/5)
Mount the levers onto the handlebar in the proper
position. Arrows must point up. Make sure there is
enough hose for the handlebar to turn freely side to
side. tighten the top bolt completely to
2.8-3.4 N•m (25-30 in-lb), so there is no gap.
Tighten the bottom bolt to the same torque.
6
Elixir User Manual
a
Torque bolt to:
5-6 N•m
(43-52 in-lb)
or
b
Torque bolt to:
5-6 N•m
(43-52 in-lb)
Mount levers with
arrows facing up No Gap
Gap
Torque bolts to:
2.8-3.4 N•m
(25-30 in-lb)
95-5015-016-000 Rev B
Elixir User Manual
5
a
right-hand front (optional)
Elixir cr Mag
To run moto-style (right-hand front), remove the levers and
bolts from both clamps. While leaving the clamps attached
to the bars, swap the levers and reinstall to the clamps.
Reinstall the bolts and torque to 5-6 N•m (43-52 in-lb).
Torque bolt to:
5-6 N•m
(43-52 in-lb)
6
align and trUE caliPErs
Squeeze the front lever 5 or 6 times, then hold. Compress the lever (with your hand or a rubber band), then snug the CPS
bolts enough to hold the caliper in place.
Spin the wheel and check for rotor drag. If there is drag, loosen the CPS bolts and repeat. Once there is no drag, torque the
CPS bolts in an alternating fashion to 8-10 N•m (70-90 in-lb). Repeat the procedure for the rear brake.
Copyright © 2009 SRAM, LLC
English
right-hand front (optional)
Elixir cr/r/5
To run moto-style (right-hand front), remove the clamps
from both levers, swap the levers and reinstall the clamps,
arrows face up, as in step 5. Torque the bolts to 2.8-3.4
N•m (25-30 in-lb).
Torque bolts to:
2.8-3.4 N•m
(25-30 in-lb)
Torque bolts to:
8-10 N•m
(70-90 in-lb)
(in an alternating fashion)
7