Evolution EVOMAG 42 Manual Del Usuario página 8

(>9.15) aSSEMBly aND PREPaRaTioN
waRNiNg: This machine must not be connected to a
power source until all assembly and preparation has
been completed and a safety check carried out. (<9.15)
assembly
remove the machine from the case and check that all
accessories are present and correct. Place the machine onto a
clean, sturdy work surface.
• Attach the three handles into the spindle hub ensuring that
they are fully seated. (Fig. 1)
• Attach the safety guard and secure in place using the
Fig. 1
supplied fixing screws. (Fig. 2)
• The coolant system should be fastened to the machine
using the ø 6 mm socket headed screw inserted into the
threaded hole located at the top left hand side of the
machines carriage. (Fig. 3 a)
• screw the lubrication quick connector into the threaded
hole located just below the motor housing on the left hand
side of the machine. (Fig. 3b)
• insert the free end of the delivery hose into the quick connector.
(9.16)
Fig. 2
Note: To release the delivery tube from the quick connector
push the collar towards the brass union and withdraw the
delivery tube.
(9.17)
Note: For some operations it may be convenient to remove
the coolant tank and supply tube, and to use alternative
coolant application methods.
(>9.18)
TESTiNg
Fig. 3
waRNiNg: This machine has ClAss 1 insulation and MusT
be earthed. Any power socket that this machine is connected
to must be grounded to earth. Ensure that both operating
switches are in the 'OFF' position before connecting the power
cord to the socket.
waRNiNg: The power cord assembly is a custom terminated
one. replacement should only be carried out by a qualified
technician. Only use replacement parts recommended by
Evolution Power Tools.
14
www.evolutionpowertools.com www.evolutionpowertools.com
(<9.18)
• place the machine onto a piece of clean 10 mm thick mild
steel plate that is larger than the magnetic base of the
machine.
• Connect the plug into a mains supply socket.
• switch on the socket. (uK only)
• operate the red switch (Fig. 4) situated at the rear of the
machine to energise the magnet.
• Check that the machine is firmly attached to the Mild steel plate.
• operate the black motor switch located on the top of the
machine. (Fig. 5)
• Allow the motor to run for a few seconds to check for any
unusual noise or vibration.
• Do not use the machine if any vibration or unusual noises
are detected or if magnetic adhesion is questionable. Have
the machine serviced by a qualified person, or if under
warranty refer to the guarantee agreement.
• Turn 'off' the machine when all testing has been
completed.
(9.19)
iNSTalliNg a cuTTER
Select a cutter suitable for the operation to be performed.
Check the cutter to ensure that it is sharp and is not damaged
in any way.
• insert the pilot pin into the cutter ensuring that it slides
smoothly. (Fig.6)
• raise the cutting head to its highest position.
• Check that the cutter securing set screws located in the arbor
are not protruding into the spindle bore. (Fig.7)
• Align the two flats on the cutter shaft with the grub screws in
the spindle.
• start to tighten one of the grub screws and at the same time
slightly rotate the cutter backwards and forwards until the
grub screw is fully tightened. This will ensure that the grub
screw is located squarely onto the flat preventing the cutter
from becoming loose.
• Tighten the remaining grub screw.
15
EN
Fig. 4
ES
Fig. 5
FR
Fig. 6
TR
Fig. 7