Pentair Fleck 6600 Manual De Uso página 10

4 - VALVE OPERATION
4.4 OPERATION DURING SERVICE
4.4.1 METERED VALVE
In service the time of day alternates being viewed with the volume remaining. The water flow through the
unit is indicated by the meter arrow
counts down with the consumption of treated water.
under the pictogram
(1)
4.4.1A METER DELAYED REGENERATION
When the volume remaining reaches the reserve capacity (calculated by the electronics), the reserve arrow
flashes as an indication. The regeneration will initiate at the pre-set regeneration time.
When the reserve capacity is exhausted, the display will show a succession of dash and the regeneration will
initiate at the pre-set regeneration time.
under the pictogram
(2)
4.4.1B METER IMMEDIATE REGENERATION
When the volume remaining reaches zero, the regeneration starts immediately.
4.4.1C 6 CYCLES MODE (SPECIAL MODE USED FOR "WATERFALL
SYSTEMS DVGW")
This valve is in immediate and upflow regeneration,with chlorination and "pause-vacancy" position. The
particularity of the "pause-vacancy" position :
• When there is not a flow rate detected for 4 days running :
- the valve initiates a regeneration and returns in service
• When there is not still a flow rate detected for next 4 days running :
- the valve initiates a regeneration and stops at the "pause-vacancy" position
- the valve will end the regeneration and return in service only when there will be a flow rate
detected.
4.4.1D VARIABLE BRINING MODE (ONLY METER DELAYED UP
FLOW)
The valve will determine that a regeneration is required when the volume remaining drops to the reserve
capacity. The regeneration will begin immediately at the set regeneration time. The volume of the brine
depends on the volume of the softened water consummate; therefore the time of the brine refill is calculated
by the electronic.
9
that flashes in a direct relationship to flow rate. The volume remaining
(1)
6600 – 6665 – 6700 – 6765
E
N
G
L
I
S
H
(2)