Pentair Fleck 6600 Manual De Uso página 24

7 - BASIC PROGRAMMING MODE
This level includes the functioning parameters of the softener related to the site conditions.
ENTERING BASIC PROGRAMMING MODE
A- The valve is in service position. Press the
display viewed is used to set the inlet water hardness.
B- The and
C- Passing to the next display, push the
Note: depending on the current programming, certain displays will not be viewed or set.
7.1 WATER HARDNESS
Not viewed in timeclock regeneration mode or when the volume override is activated.
The unit of measure used for the parameter is °tH
Ex.: Hardness 30 °tH(1)
7.2 WATER HARDNESS AFTER THE MIxING VALVE (P)
Not viewed in timeclock regeneration mode, with the volume override activated, or in US format, or if 8 set
on 1 .
(2)
Press button.
with the
Ex.: Hardness after the mixing valve 6 °tH(
7.3 SYSTEM CAPACITY
Press the button
display format chosen(1). This display is used to set the capacity of the softener. If required, the electronics
will calculate a reserve. Adjust the value with the
Ex.: Capacity 1200 m3° tH
7.4 REGENERATION TIME
Not viewed in meter immediate regeneration mode.
Press the
Ex.: Regeneration at 2:00 A.M.
(1) The unit of measure depends on the display format chosen.
All examples above are based on the cubic meter format (see point 6.17).
23
6700 / 6765
set buttons are used to set the parameter values of different displays.
The letter "P" identifies this parameter. The unit of measure is the °tH(1). Adjust the value
and set buttons.
. The red led next to the symbol
:
(1)
button. Set the regeneration time with the
button for 5 seconds. The program arrow turns on and the first
button.
. Adjust the value with the
(1)
:
1)
turns on. The unit of measure used depends on the
and set buttons.
and set buttons.
6600 – 6665 – 6700 – 6765
and set buttons.
[H - - - - 30]
[P - - - - 6]
[- - - -1200]
[--2:00--]
E
N
G
L
I
S
H