Master audio B Serie Manual Usuario página 4

• rst
1 order LPF & 3
•
Rubber feet for desktop use
•
2x M5 insert nuts for optional SP-5A bracket
2. CONTROL AND CONNECTION PANNEL (Active cabinet)
A: SPEAKER OUTPUT connector: Output signal to feed the right
passive speaker (4 ohm)
B: 5-pin terminal block stereo INPUT connector: Connect the audio
source to this connector (balanced, sensitivity 1.5V)
C: L&R RCA stereo INPUT connector: Connect the audio source to
this connector (unbalanced, sensitivity 1V)
D: 3.5mm stereo Mini Jack INPUT connector: Connect the audio
source to this connector (unbalanced, sensitivity 0.775V)
E: 3.5mm Mini Jack SUB OUT connector: When desired, connect an
active subwoofer to this output for increasing bass reproduction
F: 3.5mm Mini Jack LINK OUT connector: If necessary, connect to
another pair of active speakers
G: POWER/STANDBY LED
(power switch set to ON or STBY). Illuminates in red when in the
standby mode (power switch is set to STBY)
H: VOLUME: Rotate the button to adjust the audio volume
I: TREBLE: Rotate the button to control de treble
J: BASS: Rotate the button to control de bass
K: POWER switch: For tuning the unit ON, OFF, STBY shutoff
L: AC-Input power supply: Connect to the AC power cord. For your
safety, use always a power outlet with ground terminal
1
In the STBY mode, the LED illuminates green if an input signal is detected
and illuminates red if idle for over 2 minutes
2
When selecting the STBY shutoff mode, the speaker enters the standby
mode when idle for over 2 minutes (only 0,7W consumption)
rd
-order HPF built-in a two-way crossover
1
: Illuminates in green when powered
2