Blade Care - BaByliss PRO ROSEFX FX788RG Instrucciones De Operación

USER MAINTENANCE INSTRUCTIONS
REPLACEMENT (REMOVAL) OF BLADE SET
To remove blade set from your trimmer, make sure the trimmer is in the
"0" position. Remove the blade set by placing thumb against the smaller
cutter and pushing forward, releasing the cutter from the trimmer
housing. Replace with new cutting system and reverse the removal
procedure, only this time, place your thumb on the large cutter and snap
into place.
MAINTENANCE OF THE BLADE
Always apply oil to the blades before and after use. This will ensure
maximum cutting performance. Hold trimmer away from your body in
a downward position and apply oil on the front and sides of the cutter
blade. Wipe excess oil off with a soft, dry cloth.

BLADE CARE

Because the trimmer blades are precision-made for a very special use, they should
always be handled with care and cleaned regularly to ensure maximum performance.
Each time you finish using the trimmer, take the cleaning brush provided and brush
away any loose hair that has collected in the blades. Use a clean cloth to dry the
attachment, reattach and then store the trimmer to protect the blades until the next
use.
Any other servicing should be performed by an authorized service representative, since
the appliance has no other user-serviceable parts. This product is for commercial use.
DO NOT RINSE BLADE OR TRIMMER HANDLE OR ADAPTER.
ZERO GAP ADJUSTMENT TOOL
IMPORTANT! Only ever attempt to zero gap the blades using the adjustment tool,
following the instructions very precisely.
The adjustment tool is required to adjust the blades to zero gap, to achieve a closer,
more precise cut.
Regular Zero Gap
REGULAR
ZERO GAP
Step 1.
Before placing the blade into the adjustment tool, use
the screwdriver provided to loosen the tension screws,
without removing them completely from the blade
holder.
Step 2.
Place the blade into the adjustment tool in the side
labelled 'Zero Gap'.
ZERO GAP