Blade Sharpening - BaByliss PRO ROSEFX FX870RG Instrucciones De Operación

REPLACEMENT (REMOVAL) OF BLADE SET
Step 1. Unplug the unit and adjust the taper (see
illustration A).
Step 2. Remove the screws and the fixed blade. Save
the screws.
Step 3. Lift off the small moving blade and replace it
with the new one on the plastic oscillator (see
illustration B).
Step 4. Replace the fixed blade using the screws and lightly tighten them. Adjust the
teeth as shown in illustration C, to a gap of 1/32" (1 mm) to 1/16" (1.5 mm),
and the small, moving blade as centered and parallel as possible to the fixed
blade's teeth.
IMPORTANT NOTE:
The top edge of the fixed blade must be a minimum of 1/32" (1 mm) higher than the top
edge of the moving blade, as centered as possible. This is important so that the moving
blade does not come in contact with the skin.
Be sure to add a few drops of BabylissPro lubricating oil to the blades before running.
Don't forget to tighten the screws after the blades have been aligned.
C.
Fixed Blade
Small
Moving
Blade

BLADE SHARPENING

BabylissPro cutting blades are ground from the finest quality steel with carbon and
are hardened to extend the cutting performance. As with any cutting appliance, the
cutting edges become dull from repeated usage. Increasing blade tension to force the
blade cutting would cause the clipper to overheat and reduce its motor life. When the
blade is no longer able to cut smoothly, sharpening is required or replace it with a new
BabylissPro blade set (model FX801R).
B.
A.
Plastic Oscillator
Taper
Small
Moving
Blade
1/32" to 1/16"
ADJUSTABLE TAPER LEVER
The taper lever is positioned at your thumb. You can hold
the clipper in your hand and adjust the lever at the same
time – while you are clipping.
The taper lever adjusts the closeness of the cut from
a close cut with the taper lever in the up position, to
a longer length cut with the taper lever in the down
position. To increase cutting length, slowly push the lever down. To cut closer, push
the lever up. As different cutting edges are used in each setting, using the taper lever
lengthens the life of the clipper blades.
Too much hair can slow down hair clippers. Keep the clipper on for removing hair. Then
push the taper lever back and forth quickly for several times. If you do this every time,
especially after much hair cutting, the clipper blades should remain free of cut hair. Oil
the blades after the above procedures.
DISPOSAL OF LITHIUM ION BATTERY
This clipper has a lithium ion battery. To protect the environment, these batteries should
be removed and properly disposed of when the unit is no longer operating. To remove
the battery block for disposal or recovery, follow these instructions:
1. Disconnect the clipper from household outlet.
2. Discharge the battery pack completely before removing.
3. Remove the blade and bottom cap.
4. Remove 4 screws and open cover.
5. Remove the screw that fastens the printed circuit board to housing. Lift printed circuit
board out.
6. Unplug lithium ion battery.
7. To protect the environment, do not dispose of your battery with your ordinary
household waste. For more details on recovery of material and waste-treatment
facilities, please contact the waste disposal services in your region.
Close Cut
Longer Cut