Assembling The Drive-Tube; Mounting The Tube-Drive Assembly On The Brackets; Wiring; Commissioning - SOMFY Zigbee Sonesse 28 WF Manual De Instrucciones

EN

2.1.3.Assembling the drive-tube

1] Slide the drive into the tube. Insert the wheel by aligning the wheel to the tube
profile. Insert the drive half way and then slide the crown down the drive and
insert it in the tube. Finally, push the motor inside the tube.
2] Not required, but if needed, fix the tube to the drive with self-tapping screws
or steel pop rivets depending on the dimension (L).

2.1.4.Mounting the tube-drive assembly on the brackets

(a) Standard bracket.
(b) Drive plate for specific bracket.
NOTICE
For optimal radio reception, the motor antenna should be kept straight and should be positioned outside of headrail
(if used).

2.2.Wiring

PRECAUTION
To ensure electrical safety, this Class III motor must be powered by a «SELV»
voltage source (Safety Extra Low Voltage).
Improper using battery pack may cause overheat, fire, explosion, resulting in
serious injury or death.
Plug the battery with the motor supply cable.
CAUTION
Do not unplug the battery when the motor works.
Using this drive with any products which are not listed in the attached
«Compatibility matrix» document shall also render invalid any Somfy warranty
and release Somfy from any liability.

2.3.Commissioning

NOTICE
• The orange LED blinks continuously in setting mode.
• To save battery power, if no Zigbee network is detected after a few minutes, the drive will stop searching for a network
and the LED will turn off. Briefly press the programming button on the drive head to reactivate the search.
• Green LED blinks once when any order from paired product or application is received.

2.3.1.Waking up the drive

1] For initial unpackaging of drive, wake up the drive by briefly pressing the
motor head programming button or plugging on the charger.
g The motorised product briefly moves up and down and green LED lights
on for 2 seconds.
2.3.2.Start-up
To set the drive, you need to access and use Set&Go Connect application, you must have a compatible phone or mobile
device and access to the internet.
The App is downloadable for free from Apple Store platforms and Google Play Store on the following mobile devices:
®
▪ Apple iPhone mobile phone or mobile device with iOS operating system running iOS 11 and later.
4
1]
2]
(a)
©
Copyright 2021 SOMFY ACTIVITES SA. All rights reserved.
Sonesse 28 WF Zigbee
(b)