VLX 416S Manual De Instrucciones página 42

Ocultar thumbs Ver también para 416S:
Tabla de contenido

Publicidad

ardous to health (dust, gas, etc.) or in unsuitable environments.
This machine is intended for use in commercial applications, such as hotels, schools, hospitals, factories, shops
The machine must only be used indoors. The machine must be kept indoors at all times.
The machine is designed to operate in temperatures between +4°C and +35°C. It can be stored in temperatures
between +0°C and +50°C when not in use.
The machine must be used at an altitude below 2000 m.
The machine is designed to operate at relative humidity levels between 0% and 95%.
Never use the machine on slopes or ramps of more than 2%. In the case of slight slopes, do not use the machine
transversally, always manoeuvre with care and do not reverse. When transiting steeper ramps or slopes, take the
utmost care to prevent tipping and/or uncontrolled acceleration. Tackle ramps and/or steps with the front of the
machine raised only.
Never park the machine on a slope.
and make sure it cannot move accidentally.
Always pay attention to other people, especially children, in the place where you are working.
Children must be supervised to make sure they do not play with the machine.
The machine is not intended for use by persons (including children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless they are supervised by a person responsible for their
safety and have received instruction in the use of the machine.
Never use the machine to transport people or goods or to tow things. Do not tow the machine.
Never rest objects of any weight on the machine for any reason.
Never obstruct the ventilation and heat dispersion openings.
Never remove, modify or circumvent safety devices.
Numerous unpleasant experiences have shown that a wide range of personal objects may cause serious acci-
dents. Before beginning work, remove jewellery, watches, ties, etc.
The operator must always use personal protection devices: protective apron or overalls, non-slip waterproof
shoes, rubber gloves, protective goggles and ear protectors and mask to protect the respiratory tract.
Keep hands away from moving parts.
mend keeping detergents out of reach of children. In the event of contact with the eyes, wash immediately with
abundant water. If ingested, consult a doctor immediately.
Make sure the power sockets used for the models with cable or battery charger are connected to a suitable earth
Make sure the electrical characteristics of the machine (voltage, frequency, power) given on the nameplate cor-
respond to those of the mains electricity supply. The machine with cable has a three-wire cable and a three pin
earthed plug for use in an appropriate earthed socket. The earth wire is yellow and green. Never connect this wire
to anything other than the earth contact of the socket.
Battery charger: check the power cable regularly for damage. In the event of damage, do not use and have it
replaced by a specialised service centre.
To recharge the batteries, always use the battery charger supplied with the machine.
It
is
indispensable
plicable
legislation.
avoid surface leakage current. Protect the batteries from impurities such as metal dust.
Never rest tools on the batteries as they could cause short circuits leading to explosions.
When using battery acid, always follow the relative safety instructions scrupulously.
When using cable models, take care not to crush or pull the power cable.
While using the machine, make sure the rotating brush does not come in contact with the power cable (cable
powered version).
Check the power cable regularly. If damaged, do not under any circumstances use the machine. Replace it with
one of the same type or contact a specialised service centre (cable powered version).
Never wash the machine with water jets.
mains power supply or removing the fuse from the battery bridge) and do not tamper. Contact a service centre
authorised by the Manufacturer.
All maintenance operations must be performed in an adequately lit place and only after disconnecting the machine
from the power supply( in cable models, unplug the machine from the mains power socket, in battery models,
to
respect
the
The
batteries
should
battery
manufacturer's
always
be
kept
GB
instructions
and
ap-
clean
and
dry
They
15
-
to

Publicidad

Tabla de contenido
loading

Productos relacionados para VLX 416S

Tabla de contenido