Mounting And Adjusting The Squeegee; Moving The Machine When Not In Operation; Mounting And Changing The Brush/Drive Disks; Detergents - Instructions - VLX 416S Manual De Instrucciones

models only), used to reduce suction motor power by 20%, to activate this function, operate the "Brush

Mounting and adjusting the squeegee

Depending on the type of squeegee mounted on the machine, follow the instructions below to install:
For perfect drying, the squeegee must be adjusted in such a way that the edge of the rear blade bends during

Moving the machine when not in operation

Proceed as follows to move the machine.

Mounting and changing the brush/drive disks

During brush/drive disk attachment and release, pay attention to brush rotation.
Never work without the brushes and drive disks correctly installed.
Standard version with brushes and drive disks
Brush/drive disk attachment:
of the machine by levering on the handle, then lower it onto the brush, centring it with the brush cover. Operate
is not successful, press on the handle again and repeat the centring and repeated operation of the brush lever.
Brush/drive disk release:
After a few pulses, the brush (or drive disk) is released and falls to the ground.

Detergents - Instructions

Always dilute the detergent according to the manufacturer's instructions. Do not use sodium hypochlo-
rite (bleach) or other oxidants, particularly in strong concentrations. Do not use solvents or hydrocar-
bons. The temperature of the water and detergent must not exceed the maximum indicated in the techni-
driers.
For a complete and up-to-date list of the detergents and chemicals available, contact the Manufacturer:
DANGER
WARNING
WARNING
GB
-
19