Springlane Elisa Manual De Instrucciones página 26

Ocultar thumbs Ver también para Elisa:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 73
Ice cream and yogurt removal
1. Ice cream and yogurt are ready when the
display shows "00:00". Before removing
the product, switch the appliance off
using the ON/OFF button and unplug it
from the socket.
2. Remove the transparent lid.
3. Take the container out of the appliance
and carefully pull the mixer out of the
ice cream. If the ice cream container is
frozen slightly and cannot easily be lifted
out of the recess in the housing, wait for
a few minutes and try removing it again.
4. Fill ice cream and yogurt into suitable
containers. Refrain from using sharp or
pointed objects, but rather use a plastic
or wooden spoon, to avoid damaging the
ice container. We recommend silicone
dough scrapers.
5. If you are finished making ice cream,
switch off the appliance with the start/
stop button and disconnect the plug.
Cooling only-mode
This program is used for cooling liquids
without agitation. The pre-chosen time for
the cooling only program is 30 minutes.
It is shown on the display as "30:00". The
control knob can be used to extend or
shorten the time minute-wise. The mini-
mum time for this program is 5 minutes;
the maximum time is 60 minutes .
26
Mixing Only-mode
This program is used for agitating liquids
without freezing. The pre-chosen time for
the cooling only program is 10 minutes.
It is shown on the display as "10:00". The
knob can be used to extend or shorten the
time minute-wise. The minimum time for
this program is 5 minutes; the maximum
time is 60 minutes.
After-cooling function
Ice cream
As soon as the ice cream program is
finished the display will show „00:00If
the ice cream is not taken out within 10
minutes after preparation time is up and
no other button is pressed, the ice cream
machine will automatically go into cooling
mode every ten minutes for 1 hour. After
10 minutes, an acoustic signal will sound
and the device switches to standby mode.
You can manually extend the after-cool
function for up to one hour by selecting
the "COOLING ONLY" function and
setting the desired time.
Yogurt
As soon as the yogurt program is finished
the display will show „00:00". The device
will start the after-cooling function and
the display will show "COOL". The yogurt
will be cooled for 15 minutes. Afterwards,
the ventilator and compressor will switch

Publicidad

Tabla de contenido
loading

Tabla de contenido