Samsung SCC-С4233 Manual De Usuario página 32

FLICKERLESS
When this is set to [ON], the shutter speed is set to 1/100 sec (for
NTSC) or 1/120 sec (for PAL) to prevent from flickering by the
discordance between vertical synchronization frequency and
on-and-off frequency of the light.
REVERSE
It is used to mirror video signals horizontally, vertically, or both.
DETAIL
It is used to control the horizontal or vertical distinction.
Y-LEVEL
It is used to set the levels for the Sync signal and the entire brightness
signal of the video signal.
C-LEVEL
It is used to set the levels for the Burst signal and the entire colour
signal of the video signal.
POSI/NEGA
It is used to output as it is, or mirror the video brightness signal.
RS-5
If you press the SETUP switch when [...] is selected in the [RS-485]
menu, the corresponding screen appears.
(SPECIAL)
LANGUAGE..
VIDEO.SET.
RS-485..
ZOOM.SPEED..
DIGITAL.ZOOM..
DISPLAY.ZOOM..
SYSTEM.INFO..
CTRL.TYPE..
V-SYNC..
RET
You can set the PROTOCOL, BAUD RATE, and ADDRESS (range: 0
to 255) for this communication.
2
ENGLISH
...
...
4
OFF
OFF
...
A
INT
(RS-485)
PROTOCOL..
BAUD.RATE..
ADDRESS..
RET
SAMSUNG
9600
0