Adjusting The Flow Time; Adjusting The Range; Hygiene Flush - Franke AQCT0025 Instrucciones De Montaje Y Uso

12. Adjusting the flow time

You can adjust the flow time from 10 seconds to 5 minutes seconds using the
remote control (not part of the scope of delivery; see Accessories,

13. Adjusting the range

You can adjust the range for body reflection using the remote control (not part of the
scope of delivery; see Accessories,

14. Hygiene flush

☞
At the factory, the hygiene flush function is set so that water flows for 10 seconds 24
hours after the flush was last activated.
You can adjust the hygiene flush parameters using the remote control (not part of the
scope of delivery; see Accessories,
You can choose an interval of 0, 8, 24, 48, or 72 hours for the hygiene flush function
(0 = hygiene flush deactivated). You can adjust the flow time from 10 seconds to 10
minutes.
Display of hygiene flush on the fitting
14.1 Hold your hand around 10 cm from the sensor for 3 seconds.
14.2 Between the 1st and 2nd flashing of the LED, remove your hand from the sensor.
• Hygiene flush active: The LED flashes quickly 4 times.
• Hygiene flush inactive: The LED flashes slowly twice.
Activation/deactivation of hygiene flush on the fitting
14.3 Hold your hand around 10 cm from the sensor for 3 seconds.
14.4 Between the 6th and 8th flashing of the LED, remove your hand from the range of
the sensor.
• The LED does not flash.
14.5 After between 3 and 10 seconds, hold your hand around 10 cm from the sensor
again.
14.6 Once the LED has flashed three times, remove your hand from the range of the
sensor.
• The LED flashes quickly 4 times. The hygiene flush is active.
or
• The LED flashes slowly twice. The hygiene flush is deactivated.
8
chapter 20).
chapter 20).
chapter 20).