Graphite Brushes; Replacing Led Strip; Sawdust Chambe; Disc - Bona Edge UX Manual De Funcionamiento Y Mantenimiento

Routine Maintenance (Cont.)

Graphite brushes

The motor has two graphite brushes that must be checked every six months or after 500 hours of operation.
The check the brushes carry out the following procedure:
1.
Unplug the machine from power supply, before remove 3
screws on the upper black shell.
3.
Remove the end fixing screws
on the wire for each brush,
then pull the brush spring
backwards and remove the
brush.
When fitting new brushes, ensure the cables are away from the motor, before remounting
the cover.
18
Bona Edge UX
2.
Remove the burnished screws from rear shell.
4.
Check the brushes. If one of
the brushes is shorter than
12 mm replace both brushes.
Routine Maintenance (Cont.)

Replacing led strip

1. 2.
Follow the 'Graphite brushes'
(pag.17) up to point 3.
Remove 2 screws on the led guard and replace led strip.
Replacing dust capture strip
1. 2.
Follow the 'Replacing the
cogged belt' (pag.16) up to
point 3.
Remove 2 screws on the side arm and internal plate.
Sawdust chamber
Hoover the sawdust from the chamber regularly to prevent the hazardous accumulation of dust.

Disc

Check the disc surface regularly. Remove any dirt.
EN
Bona Edge UX
3.
Reassemble all parts.
19