Starting Machine Description; Machine Use; Working Method; Starting The Machine - Bona Edge UX Manual De Funcionamiento Y Mantenimiento

Starting Machine Description

Machine use

The machine is intended for the edge sanding of wooden floors. It may be used on newly laid and untreated floors and existing
floors that have been treated with lacquer or oil.
The main function of the machine is to serve as a complement to a belt or a drum sander for sanding edges.
The machine has been thoroughly checked and approved before leaving the factory.

Working method

When sanding, hold the machine, use both handles and move the machine in circles in the direction of rotation over the surface
which is to be sanded. It is important that the machine rests on three points, both the wheels and the sanding disc.
The best result is obtained by letting the machine work with its own weight.
When using fine abrasives you must be careful not to make any burn marks due to high friction created.
In addition to the points noted the sanding must be adapted to the type, pattern and composition of the floor.

Starting the machine

1. 2.
Become familiar with Use a remote control industrial vacuum cleaner intended for wooden dust (maximum length
the machine and read all of pipe: 10 m - pipe diameter: 38 mm). As an alternative, fix the bag by tying the cord over the
instructions and safety suction elbow flange.
notices. Ensure that all
operators read this manual.
3. 4.
Fit the disc in accordance Locate the power supply. The socket must be compatible
with the 'Abrasive Assembly with the plug. To avoid electrical hazards the socket must be
Procedures' (pg.14). grounded with a 16 A fuse. Connect the plug to the socket.
12
Starting Machine Description (Cont.)
Bona Edge UX
Starting the machine (Cont.)
5.
The disc does not stop immediately! Take care not to touch it
with any part of the body during this phase.
A safety sensor is fitted to the machine. If the machine is too
inclined the motor stops. To recommence sanding repeat the
start-up operations described above.
6.
Raise the disc so that the Keep the machine moving
machine is only resting on when the abrasive disc is
the floor with its wheels. lowered and put on the work
Press one of red starting surface.
lever and then press the
contact switch on the upper
black shell of machine.
Allow the motor to "rest" during periods of heavier use.
EN
Bona Edge UX
7.
To stop the machine, raise the
disc so that the machine is
only resting on the floor with its
wheels. Then release both red
starting lever.
13