Application; Cut Wood At Any Angle With ±0.1º Accuracy; Use The Precision Fence Accessories - RIDGID DMG9015 Manual Del Operador

APPLICATION

CUT WOOD AT ANY ANGLE WITH ±0.1º AC-
CURACY
WARNING:
Always keep the miter fence away from the blade when
guiding the cut with this digital miter gauge. Serious
personal injury may result if the metal fence is cut.
NOTE:
Before making any cuts, the digital miter gauge must first be
calibrated.
1. Fit and calibrate the digital miter gauge to the table as
described in the preceding section, "CALIBRATE THE
DIGITAL MITER GAUGE TO THE TABLE-SAW-BLADE
ASSEMBLY."
2. With the miter gauge bar securely in the table groove, turn
the digital miter gauge on.
3. Unlock the locking handle.
4. Swivel the miter gauge head to the desired angle, as indi-
cated in the display, and then tighten the locking handle.
5. Securely place the workpiece against the miter fence and
begin crosscutting, following the operating instructions
for the table saw (Fig. 13).

USE THE PRECISION FENCE ACCESSORIES

This digital miter gauge offers a variety of precision fence
accessories which will allow the user to fully utilize the miter
gauge capabilities.
The precision stop gauge is designed for vertical precision;
it allows the user to cut multiple pieces with one pass, as
shown in Fig. 14.
Fig.13
The Flip Stop Gauge is a multiuse gauge, which can be used
in the top fence groove and as a solid stop gauge. To cut a
long workpiece, just flip it back, there is no need to detach it
from the fence (Fig. 15 and 16).
10
Fig.14
Fig.15
Fig.16