Auto Sleep Mode - Olivetti d-Copia 1600 Manual De Instrucciones

Auto Sleep Mode

OPERATION GUIDE
The Auto Sleep Function is a function that automatically turns the copier
off after a set period of time (1 to 240 minutes) has passed. "-" is displayed
in the No. of Copies display and all other indicators and message display
will be turned off.
This has been set to 30 minutes at shipping.
NOTE:
In the Sleep Mode state, the supply of electrical power to
everything except the operating section is stopped. When the Power
Switch is turned off, the supply of power to everything, including the
operating section, is stopped.
The No. of Copies display will show a "-" for approximately 5 seconds
after the Power Switch has been turned off.
Press [Energy Saver] in order to resume copying operations. The
recovery time before copies can be made is less than 20 seconds.

Auto Sleep Mode

The Auto Sleep Function is a power-saving function that automatically puts
the copier into Sleep Mode when no copying operations have been
performed for a set period of time.
In the case of copiers, the amount of time spent idling rather than copying
is large, so the amount of power consumed during idle operation makes up
the largest share of their power usage. The consumption of power during
idling or when someone forgets to turn the copier off after work can be
reduced through the copier unit automatically entering the Sleep Mode and
the electric bill reduced as a result.
NOTE:
The time interval before the Auto Sleep Mode engages can be
changed. (Refer to Sleep Mode Transition Time on page 5-22.)
The Auto Sleep Mode can be deselected. (Refer to Auto Sleep Setting on
page 5-21.)
Basic Operation
3-9