Installation Procedures; Cooler Assembly; Installation In Window - MasterCool MCP Serie Manual De Instalación Y Funcionamiento

INSTALLATION PROCEDURES

WARNING: Do not connect electrical power to the unit
until the installation is completed.
The MasterCool MCP Series cooler can be installed in a
sash-style or a slider- style window.
Alternatively, this unit is approved for in-wall installations.
In all installations, the following clearances are required:
Width: 22"; Height: 22" ; 4" clearance above the exterior
cabinet is needed for maintenance.
Parts Included:
• Cooler Unit
• Mounting brackets (4)
• Accordion spacers (2) Hardware kit
Tools & Materials Required:
• Drill (power or cordless)
• Assorted drill bits (for drilling pilot holes for mounting
hardware)
• Adjustable Wrench
• Phillips Head Screwdriver
• Silicone or all-weather caulk for sealing in ll panel to
window frame
• Length of ¼" copper or plastic tubing
• Sill-cock valve
• Bubble level
• Spacer material (as required)
3. PULL BACK GUARD
AWAY FROM UNIT

Installation in Window

1. Remove screen (as needed) and make sure window is
opened to its maximum height. From the exterior of the
window, slide the fan assembly section into the window.
Have the person on the interior adjust the exact place-
ment of the unit for aesthetics and correct lengths of the
two accordion spacers (included).
Note: After identifying the position for installation,
place a bubble level on top of the unit and make ad-
justments to ensure the unit will be level when instal-
lation is complete. It is recommended to verify unit is
level at various points during installation.
2. Closing the window may help hold the unit in place during
the following steps – Push the unit into the window until
the bottom is ush with the outside wall or spacer (not
supplied) as shown in the illustration.
OPEN UNIT UP
1. REMOVE 4 SCREWS FROM
BACK MEDIA GUARD
2. PUSH UP ON BACK GUARD

Cooler Assembly

1. Remove unit from box. Verify that all parts are included.
2. Remove all packing materials.
CALL 1-800-643-8341 IF YOU FIND PARTS
MISSING OR HAVE ANY QUESTIONS
3. With the unit in an upright position, remove 4 screws
holding the back media guard, and separate the front and
back sections. Pull the fan assembly forward (about 6")
until it is fully engaged with the mating part and secure in
place using the 12 supplied screws.
4. Verify that assembly is secure to prevent vibration be-
tween the two sections.
NOTE: Ensure the location selected for installing the
unit is strong enough to support the unit and will ac-
cept the mounting hardware. The operating weight of
the cooler is 93 pounds.
NOTE: A minimum of two people is required for
installation.
SECURE FAN HOUSING
4
EXTEND HOUSING AND
ATTACH IT TO
COOLER BODY FRONT
WITH 12 SCREWS
3. From the interior, locate
the two tracks on the
bottom of the fan assem-
bly. Drill pilot holes as
necessary and install the
two window sill brackets
as shown in illustration on
following page.