Klarstein 10029239 Manual Del Usuario página 24

Using the Touch Controls
• The controls respond to touch, so you don't need to apply any pressure.
• Use the ball of your finger, not its tip.
• You will hear a beep each time a touch is registered.
• Make sure the controls are always clean, dry, and that there is no object
(e.g. a utensil or a cloth) covering them. Even a thin film of water may
make the controls difficult to operate.
To start cooking
1. Touch the ON/OFF control. After power on, the buzzer beeps once, all displays show " – " or " – – ", indica-
ting that the induction hob has entered the state of standby mode.
2. Place a suitable pan on the cooking zone that you wish to use. Make sure the bottom of the pan and the
surface of the cooking zone are clean and dry.
3. Select a heating zone by touching „+/-" control, and a indicator between the key will flash, the default po-
wer setting is levels "5". If you don't choose a heating zone in 1 minute, the induction hob will automatically
switch off. You will need to start again at step 1. You can modify the heat setting at any time during cooking.
If the display flashes
• you have not placed a pan on the correct cooking zone or,
• the pan you're using is not suitable for induction cooking or,
• the pan is too small or not properly centered on the cooking zone.
No heating takes place unless there is a suitable pan on the cooking zone. The display will automatically turn
off after 2 minutes if no suitable pan is placed on it.
When you have finished cooking
1. Turn the cooking zone off by scrolling down „-" to "0". Make sure the display show "0".
2. Turn the whole cooktop off by touching the ON/OFF control.
3. Beware of hot surfaces! "H" will show which cooking zone is hot to touch. It will disappear when the surface
has cooled down to a safe temperature. It can also be used as an energy saving function if you want to heat
further pans, use the hotplate that is still hot.
Operation Item 10029239
alternately with the heat setting, this means that:
24